The only issue is the original door stop has a precut slot in the door stop for kerf weatherstripping.
This is kind of a tough one to give advice on as each door assembly can be different.August 29, 2018 at 11:30 am #695217 Sorpa wrote: Router with an edge guide.There is visible rot at the bottom four inches.Doors door-frame weatherstripping up vote 0 down vote accepted, yes, you are correct that the slot may be used for insertion of kerf-type weather-stripping, either for the Z-compression-foam shown in your link or a simple "flexible bulb" plastic edge that is positioned in the gap.I wish I thought of that sooner then I could have put it on my table saw and two passes I have a perfect slot.This video shows details of a very commonly used technique for anchoring cast stone (dry-vibrant tamp), architectural wet-pour precast, or, gFRC (Glass Fiber Reinforced Concrete) panels.The AAS design and engineering process includes details for installation anchorage to confirm the final design aesthetic in the initial review, design assist process.What blade or bit?August 30, 2018 at 10:02 pm #695397 Boschmanbrian wrote: You mentioned it has to be cut in place, you mean that stop kurf?
How would you make such a slot?
August 29, 2018 at 2:39 pm #695236 You mentioned it has to be cut in place, you mean that stop kurf?
The new pieces I put in are 12-18 tall.Can you measure and then cut before you install, Id do like Sorpa mentioned router and guide Not in this case as I had the weatherstrip removed and didnt remember I needed the slot until everything is installed.August 29, 2018 at 8:37 am #695206, miamicuse wrote: wrote: Miamicuse facebook slots free games gambling wrote: Doobie wrote: How deep and wide is the required slot?No perfect but no one would see it once the weatherseal snapped.August 25, 2018 at 10:37 am #694713, doobie wrote: How deep and wide is the required slot?I was actually thinking about doubling the OMT blades and see if that would work on a scrap piece of lumber.It looks like the previous owner put white epdm rubber foam tape over a hard but flexible vinyl strip that was inserted by the side of the door stop.August 25, 2018 at 1:56 pm #694741.Might be a little wobbly, but itll be covered so it wont be too obvious.